|
Post by bruno42 on Feb 7, 2020 13:56:06 GMT
Hello Guys,
I can see various Development modes, but I didn't found any documentation, I have some questions to Gurus: - What the differences between modes ? - What is the consequence of using it ? (is that permanent or can we permanently damage control unit) - Can we revert to normal ? (and should adaption changes be reverted too ?)
Thanks
|
|
|
Post by vwjap on Feb 7, 2020 14:49:40 GMT
Never really worked it out personally but I presume different modes let you in to different levels of programming and there are adaptions for the different modes too
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Feb 7, 2020 16:59:11 GMT
I also dont know the answer but there is some information here forum.obdeleven.com/thread/1250/change-service, not sure if its relevant to your car. I am pretty sure it runs VW Diagnostic by default and if you disconnect and re connect it will revert to that mode had you changed it I have also seen an error message that shows WRONG DIAGNOSTIC MODE but unhelpfully it dont tell you the correct one. I am also aware that some of the Basic Settings need to be run under the EOL (this is the mode they use to check the car once it has been built) but other than that I have changed the mode a few times (as stuff was not working) and reverted back and had no issues but golden rule for this kit is if not sure and cant get an answer dont do it.
|
|
|
Post by bruno42 on Feb 12, 2020 15:55:22 GMT
Thank you ! I was not expecting any quick response due to the current momentum of this forum The quoted thread is the only thing we have but disappointing.. I'm trying to workaround a "(31) Function not available" on A5 - Frt Sens. Drv. Assist to change inactive threshold and power support, but I get the (31) code. I have hints it could work due to a complaint here
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Feb 12, 2020 16:17:07 GMT
firstly have you tried clearing app data and what car do you have and year
|
|
|
Post by bruno42 on Feb 12, 2020 16:30:33 GMT
Hello testeronline, I tried with two devices but I didn't tried to clear the app completely, I'll try that. However, I was not too surprised since a friend's VCDS was not able to code it either The car is a 2015 Audi A3 (8VS)
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Feb 12, 2020 17:40:21 GMT
bruno42, i have tried this on my 2014 mqb platform car and get the same error. I can confirm this function needs to be set to development mode to enable any changes to this field. But I have personally disabled the Lane Assist function as I dont like it at all so it may be there is a conflict on my car where I am trying to adjust something that relates to Lane Assist (which i have coded off).
|
|
|
Post by bruno42 on Feb 13, 2020 14:10:07 GMT
Thanks for doing that, I appreciate I got ACC+front cam from factory, so far it works quite good with some limitations but nothing making it a no deal. The thing I'm tying to enhance is system thinking I have no hands on wheel on long straight lines (where my hands agree with the system's trajectory for a while), so wanted to extend "inactiv time" ...
|
|