|
Post by dsgauto on Jun 20, 2020 23:39:05 GMT
Hi,
I have a Passat GTE with full assist pack and LED system and I want these to be done:
1. Traffic Jam Assist with ACC and Lane Assist, they only work from 64km/h... but I see that it was a option before from 2017 I have 2016 in Norway. Have seen sevral cars with that also activated trough OBDEleven. How? I have activated «traffic jam depented linear tracking» & «traffic jam assistant in car menu»... doesnt work bellow 64.
2. Dynamic Light Assist works bellow from 64 too. Its possible to change it at A5 module, but didnt find the thing I was going to edit to 30km/h or something. This is from another forum «Go into A5 Module, Adaptations, and click "activation speed for high beam assistant"» ..
3. The Dynamic Light Assist does also have foglight built in the headlights... it cames on when you reverse, blink left or right. Is it possible to activate that together with high beams or low beams together? The Passat lights has bad light spread... not sure which "leucthe" it is... I know that the A3 8V with full led its possible and seen the same thing on a Audi A6, when that light goes on when I reverse it makes a huge difference!
|
|
|
Post by newty on Jun 21, 2020 10:15:14 GMT
Sorry:
1) No. Not possible with OBD11. Use VCP instead, parameter set change needed, which is not possible with OBD11 or VCDS 2) No. Not possible in B8. This was possible for Golf7 until 2016 and its derivated cars. The older camera used until then has this option, the newer 3Q0-branch does not. 3) I think you are talking about static cornering lights: Static cornering lights cannot (and shall not in some models (heating up!)) be coded to do anything different than static cornering.
|
|
|
Post by dsgauto on Jun 23, 2020 22:23:29 GMT
Okay thx for a nice answer But nr.3 again Yes talking about the static cornering lights which turns on reverse and turning the steering. Its LED on this car, so won't heat it up if I only active it as high beam I think? so the question is how do I do so?
|
|
|
Post by newty on Jun 24, 2020 17:12:27 GMT
I know that the static cornering lights are now LED. Still, they are not designed to be lit for a longer time. I do not say that they aren't able to technically, but they still are wired as the old halogen bulbs and they are very special kind. Either way, they are controlled by either the 55 or 4B light distribution modules and cannot be set to do anything "off the charts". You can easibly manipulate all fixtures with an direct wiring to the BCM with the "Leuchte" adaptions, but that is not the case here. You could possibly turn on the foglights (using the NL Leuchte sets), but this is likely not what you want...
|
|