|
Post by rsborsti on May 12, 2020 8:23:21 GMT
Hi,
the new Tarraco always has Lane assist enabled after startup. Unlike on Ateca, where the last used setting was stored. So you always have to run through the menu to disable lane assist.
There seems to be a coding availble (OBDApp offers the memory option, so remains at last used setting after startup)
Can you guys maybe investigate or does anyone know what codings are required? Seems Touareg and T-Roc suffer from the same issue. Tried a bit in the long coding section
There's an option under A5 Bit 3 saying: last setting. With the box enabled. It has two options: last setting, active after iginition.
I tried both but didn't see any effect.
Thx
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 12, 2020 11:08:17 GMT
|
|
|
Post by rsborsti on May 12, 2020 12:07:11 GMT
Thanks! Problem is, that I don't exactly know what the coding should be.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 12, 2020 14:01:05 GMT
I feel for you but as this tool supports a very wide range of cars the Dev team do not know them either.
Might be worth a chat on the seatcupra.net site as they have a few guys who use obd11 and I know there are a couple dedicated ateca forums where i am sure somebody can help - with the coding.
And you may be lucky and somebody on here will help.
|
|
|
Post by t2cool on May 27, 2023 4:21:56 GMT
Hello,
There is already an APP for Lane Assist Setting Memory for the Tarraco but it is not working on my car unfortunately. I have enable it with success and the OBD Eleven shows it as "ON" but unfortunately it does not remember the last setting. Does anyone has information on this?
Asen
|
|