Post by mox on May 11, 2020 12:12:22 GMT
I followed these steps to configure the Traffic Sign Recognition for my 2018 Passat. Everything is set and i can see my Sign recognition with the other assistance choice in my MFA and all is good up to there but yet the car doesn't show the speed signs in the MFA. The only thing i am missing is in the module 17....I do not have a byte 5 so i can't tick the bit 2. Is there an other way to bypass this or am i using the proper coding?
Thanks for your help
1. Go to Module A5 (Front Sensors ...)
2. Click on Extended Coding3. Press the button at the top right which displays a'0' and '1' to see it Bytes
Each Byte has 8 bits (from 0 to 7 included)
4. Press the right arrow down until you reach Byte 16
5. Inside Byte 16 activate bit 4 and do not modify the rest
6 Press the Validate button
7. Exit Module A5 and enter Module 5F
8. Click on Adaptation
9. Search for Car_Function_Adaptations_Gen2
10. Enter menu_display_road_sign_identification and change to On
11. Enter menu_display_road_sign_identification_over_threshold_high and change to On
12. Press the Validate button.
13. Return to Adaptation and search for Car_Function_List_BAP_Gen2
14. Enter traffic_sign_recognition_0x21 and change to Activated
15. Enter traffic_sign_recognition_0x21_msg_bus and change to ' Infotainment Data Bus'
16. Press the Validate button
17. Exit Module 5F and enter Module 17
18 Click on Extended coding
19. Press the button on the top right that shows a '0' and '1' to see it Bytes mode
Each Byte has 8 bits (from 0 to 7 included)
20. Press the right arrow until you reach theByte 5
21. Inside Byte 5 activate bit 2 and do not modify the others
22. Press the Validate button