|
|
Post by premek on Apr 20, 2020 8:35:30 GMT
Hi all, is it possible to activate it for front and rear pdc? I don't have front assist, i have only pdc with 4 front and 4 rear sensors.
|
|
|
|
Post by vwjap on Apr 20, 2020 8:47:49 GMT
I know sometimes in mine, when reversing up a bit of a hill the car slams the brakes on sometimes (presume it sees a curb or something as a obstacle)
|
|
|
|
Post by florian on Apr 20, 2020 10:50:17 GMT
vwjap hi bro, I too have disabled this function in 5f, because it detects invisible things and brakes suddenly for nothing so I preferred the disabled
|
|
|
|
Post by ofektal8 on Apr 20, 2020 12:15:43 GMT
Hi all, is it possible to activate it for front and rear pdc? I don't have front assist, i have only pdc with 4 front and 4 rear sensors. You will need to have the full 12 sensors in order for this to work, the New module that supports this function is a 12 sensor module. Also, ABS pump needs to support it so make sure it can before buying all the stuff. |
|
|
|
Post by premek on Apr 20, 2020 13:25:42 GMT
12 sensors? I'm not sure. In work we have 2018 Octavia with only 4 rear sensors and this think it have. I'll try copy coding, but im not sure where to find it. Is it in 03(abs), 76 (pda) or both?
|
|
|
|
Post by ofektal8 on Apr 20, 2020 13:29:11 GMT
12 sensors, i'm not sure. In work we have 2018 Octavia with only 4 rear sensors and this think it have. I'll try copy coding, but i don'f find it. Is it in 03(abs) 76 (pda) or both? For cats without the 12 sensors it will be quite diffcult to get the correct module, its not as common as the 12 sensor one which is everywhere. Im not sure whats the correct PN for the abs pump but if you have ACC then it is correct. Usually the new cars already have the correct pump as ACC is standard( at least in my country) |
|
|
|
Post by newty on Apr 22, 2020 13:16:27 GMT
This is maneuver braking. You will need a Parking control module generation 3 - hardware code 5qa 919 294 for 8 sensors. No other possibility.
As said, your ABS needs to support it. Try to set Byte 24 Bit 5 in ABS. If it is accepted, you should be good to go.
Coding in 76 is self explaining, ABS see above. Might need to Enable PLA3 in the Dash, just check for errors after exchanging the module.
|
|
