Steering angle sensor MQB MK7

sd82
New Member

Posts: 23

Steering angle sensor MQB MK7 Apr 15, 2020 8:50:43 GMT

Quote

Post by sd82 on Apr 15, 2020 8:50:43 GMT

I calibrated the steering angle as below...(other procedures had no effect)

• The procedures of solving this problem is very simple and take no more than 10 minutes.

• Make sure the engine is OFF and the ignition in ON from the first before you do anything.

1- Go to control units
-> (Steering assistance)

2- Live Data
-> Choose (Steering angle sensor, angle) then put OK, after that turn your steering to the middle and make sure the angle isn’t more than ( 0 ) degree, and don’t touch the steering wheel at all until you finish all the procedures.

• That’s most important step so you can have some permission i think to do some coding you couldn’t do it before and it tells you ERROR!!

3- Go to (Diagnostic session)
from (Steering Assistance) again
-> and change it to
(End of assembly line mode) (EOL).

4- Go to (Basic settings)
from (Steering assistance) again
-> choose (Steering angle sensor) and activate it and leave it unitl it turnd off by itself it may takes 60 seconds mostly.

5- turn OFF the ignition, turn it ON again
then turn ON the engine.

6- Go to (Basic settings) again
from (Steering assistance)
and choose the last one
(Steering angle sensor, zero calibration w/ steer . wheel scales)
put the value (0) degree then -> done.

after all that it must be solved and the fault and light in the dashboard disappeared, after that just turn OFF the ignition, and do final scan and clear all the faults,, that’s exactly what i did and it works 100% and all problems is solved.

Regards

sd82

Last Edit: Apr 19, 2020 5:44:10 GMT by sd82

andi49
New Member

Posts: 3

Steering angle sensor MQB MK7 Apr 28, 2020 13:21:15 GMT

Quote

Post by andi49 on Apr 28, 2020 13:21:15 GMT

Hi, a have a question for You.

I drive a MQB Passat B8. After a wheel alignment, when i drive in a straight linewhen I am driving in a straight line, the car slightly turns left.

With the steering wheel perfectly straight, I have these parameters:

Is it ok?

how can I reset these values so that with a perfectly straight steering wheel it is 0 degrees?

PS.

I tried to do your method but I don't know one thing:
in step 2. the steeringwheel should be perfectly straight or should be positioned so that the value 0 degrees is visible on the obd11 app?

Last Edit: Apr 28, 2020 13:25:23 GMT by andi49

150@186

andi49 New Member Posts: 3	Steering angle sensor MQB MK7 Apr 28, 2020 18:31:59 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by andi49 on Apr 28, 2020 18:31:59 GMT from the vag group service manual: '' 13) If steering wheel is not centred, it must be straightened after wheel alignment is finished. Then carry out basic setting for steering angle sender - G85- using ⇒ Vehicle diagnostic tester. ''
	Last Edit: Apr 28, 2020 18:32:33 GMT by andi49 150@186

Deleted
Deleted Member

Posts: 0

Steering angle sensor MQB MK7 Apr 28, 2020 18:38:24 GMT via mobile

Quote

Post by Deleted on Apr 28, 2020 18:38:24 GMT

i can think of one reason and that is when users run factory reset or other events that leave cars systems all in a state that requires this process to fix the issue

and before you say it i think the reset process should be much more difficult to use

sd82
New Member

Posts: 23

Steering angle sensor MQB MK7 Apr 28, 2020 20:44:02 GMT via mobile

Quote

Post by sd82 on Apr 28, 2020 20:44:02 GMT

Hi,

Exactly as you write testeronline and adrianvw.
This method makes sense if there is no mechanical damage...
then the car needs to be repaired...

obd11 can't calibrate the steering angle otherwise ... and I've tried several methods...

Regards
sd82

Last Edit: Apr 29, 2020 17:37:52 GMT by sd82

sd82 New Member Posts: 23	Steering angle sensor MQB MK7 Apr 28, 2020 20:54:20 GMT via mobile Quote Select Post Deselect Post Link to Post Back to Top Post by sd82 on Apr 28, 2020 20:54:20 GMT Hi, andi49 to zero the angle try using steering angle initialization ... the steering wheel must be set to 0 ° for it to work Regards sd82
	Last Edit: Apr 28, 2020 20:54:54 GMT by sd82

andi49 New Member Posts: 3	Steering angle sensor MQB MK7 Apr 28, 2020 21:32:32 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by andi49 on Apr 28, 2020 21:32:32 GMT Hi sd82, do you know how the initialization procedure works?
	150@186

sd82 New Member Posts: 23	Steering angle sensor MQB MK7 Apr 29, 2020 17:23:51 GMT Quote Select Post Deselect Post Link to Post Back to Top Post by sd82 on Apr 29, 2020 17:23:51 GMT Hi andi49, the steering wheel makes a few turns - then do not touch it you can do it with the engine off - but in adaptations you have to choose - help activation without starting the engine Regards sd82
	Last Edit: Apr 29, 2020 17:25:12 GMT by sd82

manflxsrsrwy
New Member

Posts: 1

Steering angle sensor MQB MK7 Apr 4, 2021 20:29:55 GMT

Quote

Post by manflxsrsrwy on Apr 4, 2021 20:29:55 GMT

sd82 You really saved me man, i thought doing an hard reset of the ABS module would fix the Auto Hold not working but i ended up screwing my car, with your guide i was able to get rid of all the faults and lights in the dashboard except one, after the calibration a new fault named "End stop not learned" appeard, i don't really now how i fixed it but i was able to get rid of this fault as well, i think i was in End of assembly line mode and then with the steering wheel fully to the right i clicked on the end stop reset basic setting, i did the same thing for the left side and the fault disappeard right afterwards.

Thank you so much.

jarcik
New Member

Posts: 1

Steering angle sensor MQB MK7 Jan 10, 2024 11:20:03 GMT

Quote

Post by jarcik on Jan 10, 2024 11:20:03 GMT

it's an old post, but could anyone tell me how to do this procedure correctly and if it can help with the correct angle?
I've changed the clock spring and steering wheel, but after that, I noticed that the car is pulling slowly left with a straight steering wheel, so I fitted the wheel on 1-2 teeth left to have it straight.
Now I see in the live data of the steering assistance and I've got 4.34 degrees with the straight wheel.

georgegianna: Recover Your Lost Coins with Paradox Recovery Wizard

I just wanted to express my heartfelt gratitude for your incredible help in recovering my lost funds. Your expertise and dedication have truly made a difference, and I’m so thankful for the support you’ Nov 15, 2024 19:31:32 GMT

derpandabear: Hi everyone, it's been two weeks since I've posted my question. I would greatly appreciate it if anyone can respond to my thread: forum.obdeleven.com/thread/28144/summertime-setting-mk8-golf-gti. Thanks and Best Regards! Nov 16, 2024 19:49:09 GMT