|
Post by rtnlsltn on Apr 13, 2020 4:40:40 GMT
I swapped my front pads out to an aftermarket set that has a sensor, but the brake wear light is still on. How do I reset/re-calibrate this? I've been unable to find anything substantial between here and Ross-Tech.
|
|
|
Post by gnasher on Dec 4, 2021 17:58:59 GMT
You could probably code it out, but why not (if you still have them) just cut the old wear sensor(s) off the old pads and link the wires together - bit of solder and heat shrink and you're good to go.
|
|