eli
Full Member
Posts: 129
|
Post by eli on Mar 10, 2020 5:35:11 GMT
Friends, I'm going to put "logo lights" on the doors to light up when the door is opened. Would you like to get the correct coding and which pin to install on the door module?
|
|
bert
New Member
Posts: 26
|
Post by bert on Mar 10, 2020 8:24:55 GMT
this site explains exactly how to do it then activate, and they burn
|
|
|
Post by vwjap on Mar 10, 2020 8:51:43 GMT
How many times you going to ask this?
|
|
eli
Full Member
Posts: 129
|
Post by eli on Mar 11, 2020 5:38:21 GMT
Does anyone have coding via Obdeleven? I don't have VCDS. I installed the lights but they don't work.
|
|
bert
New Member
Posts: 26
|
Post by bert on Mar 12, 2020 18:00:37 GMT
door electronics modules long coding door exit light make active
|
|
|
Post by dv52 (Australia) on Mar 12, 2020 20:01:30 GMT
^^^eli: Hi- it's done like this: - Select the Door electronics driver side module @ address hex42
- Select Coding
- if you see a screen with a bunch of numbers across the top and tick boxes down the screen, press the 0/1 button at the top RHS
- You should see a screen with a bunch of descriptors like my picture below (note: my screenshot is from the old OBD11 software, but the current software shows the same entries)
- Select door_exit_light (this is Byte 1, Bit 2) and set to active
- Repeat above procedure with the Passenger side door module @ address hex52
Don
|
|
eli
Full Member
Posts: 129
|
Post by eli on Mar 12, 2020 21:35:59 GMT
Hello, DV52. Thanks. I made these settings but it didn't light up. Do you know which pins connect the positive and negative of the light?
|
|
|
Post by dv52 (Australia) on Mar 13, 2020 1:12:59 GMT
^^^ if your light is LED type - I assume that you have the correct polarity for the LED connected to the door module. According to the information in my database the "supply" side of the Exit/Warning Light is on pin #16 on the S004 connector (see housing picture for the module below) - I think. The other side of the light is earthed - I think
If your door module doesn't have the 004 connector, the Exit/warning Light is on pin #12 on the S003 connector - I think!
Driver/Passenger Door Control Module - Housing/Connectors
Don
|
|
eli
Full Member
Posts: 129
|
Post by eli on Mar 13, 2020 4:27:24 GMT
And the grounding wire, how to proceed?
|
|
|
Post by vwjap on Mar 13, 2020 8:43:34 GMT
Tap in to the brown wire (pin4 I think)
|
|