|
|
Post by lordnikon on Feb 29, 2020 20:47:13 GMT
Do our MK7s have the side light function for street parking? i.e. if you flip the signal stalk left or right and the corresponding exterior lights will illuminate but not at full brightness. How do you enable it in OBD11?
I would want the rear side marker light(s) to illuminate instead of the rear full parking lights. Can it be done?
|
|
|
|
Post by dv52 (Australia) on Feb 29, 2020 21:22:06 GMT
^^^ For Single side Parking Light (SSPL): in the BCM (@ address hex09) - make sure that Driving light and parking light-Parklicht ueber LSS aktiviert is set to One-sided
Then pick which lamps you want to operate as SSPL and add these commands to the associated Leuchte-set:
Left side lamp
Lichtfunktion > Parklicht links (beidseitiges Parklicht aktiviert li & re)
Dimmwert > choose a low illumination level (for halogen lamps - suggest 31)
Right side lamp
Lichtfunktion > Parklicht rechts
Dimmwert > choose a low illumination level (for halogen lamps - suggest 31)
Don
Note: for Golf mk7.5 - likely the headlight lamps are NOT controlled by the BCM. Instead they will likely use LCMs (Light Control Modules). So, the Leuchte-sets for these lamps will not be activated - hence it is not possible to use these lamps as SSPL. For the front, perhaps consider the turn signal lamps - but if your car has incandescent turn signal lamps DON'T select a Dimmwert value greater than 50 (or the lamp base will overheat and the lamp holder will melt)
|
|
|
|
Post by lordnikon on Feb 29, 2020 23:12:18 GMT
I have full LEDs front and rear so no halogens. MK7.5.
Which command is for the rear side marker lights?
So Dimmwert is the brightness? What is the lowest and the highest value?
Thanks.
|
|
|
|
Post by dv52 (Australia) on Mar 1, 2020 0:35:58 GMT
^^^^ Try Leuchte23SL HLC10
Dimmwert smallest= 1 and maximum = 127 (only for LED)
If you want max illumination - try Leuchte23SL HLC10-Lichtfunktion B 23 > Parklicht links (beidseitiges Parklicht aktiviert li & re) For this you don't need to add a Dimmwert setting - because Leuchte23SL HLC10-Dimmwert AB 23 will be already set to 127)
If you want a smaller illumination, add my Leuchte-commands to Leuchte23SL HLC10-Lichtfunktion C 23 and Leuchte23SL HLC10-Dimmwert CD 23
Don
|
|
2018gti
Full Member
2018 GTI Autobahn 6-speed
Posts: 111
|
Post by 2018gti on Mar 3, 2020 3:15:04 GMT
Hey all, if that doesn’t work then use Leuchte27NSL. On North American facelift Golfs this is used for the rear side markers. Everywhere else it’s for the rear fog light.
|
|
|
|
Post by lordnikon on Mar 8, 2020 23:14:49 GMT
^^^^ Try Leuchte23SL HLC10Dimmwert smallest= 1 and maximum = 127 (only for LED) If you want max illumination - try Leuchte23SL HLC10-Lichtfunktion B 23 > Parklicht links (beidseitiges Parklicht aktiviert li & re) For this you don't need to add a Dimmwert setting - because Leuchte23SL HLC10-Dimmwert AB 23 will be already set to 127) If you want a smaller illumination, add my Leuchte-commands to Leuchte23SL HLC10-Lichtfunktion C 23 and Leuchte23SL HLC10-Dimmwert CD 23Don What does Leuchte23SL HLC10-Lichtfunktion C 23 and Leuchte23SL HLC10-Dimmwert CD 23 mean? Does it mean left and right lights?
I've been told to change ENG116959-ENG116313-Leuchte23SL HCL10 - Lichtfunktion B23 from 'not active' to Parklicht links (beidseitiges Parklicht aktiviert li & re) and ENG116959-ENG116313-Leuchte24SL HCL10-Leuchte24SL HCL10 - Lichtfunktion B24 from 'not active' to Parking light right |
|
2018gti
Full Member
2018 GTI Autobahn 6-speed
Posts: 111
|
Post by 2018gti on Mar 25, 2020 14:55:29 GMT
If you want only your rear side markers to be used then just modify Leuchte27NSL, not the other channels. Lichtfunktion A should already be set to “Standlicht allgemein” or something like that. Keep in mind tho, you can’t control the rear side markers independently.. left and right are both on the same wire. So you could set Lichtfunktion B in Leuchte27NSL to “Parklicht links” then you’d turn it on by the left turn signal. |
|
|
|
Post by lordnikon on Mar 26, 2020 13:16:34 GMT
Do I need to enable abschaltbar über Energiemanagement for Bedingungen zur Parklichtbegrenzung and Bedingungen zur Standlichtbegrenzung?
|
|
2018gti
Full Member
2018 GTI Autobahn 6-speed
Posts: 111
|
Post by 2018gti on Mar 26, 2020 15:53:40 GMT
I don't remember doing that, no. I just used Don's instructions and make sure the Parklicht uber LSS aktiviert was set to the right thing.
|
|
|
|
Post by lordnikon on Jan 22, 2022 0:15:19 GMT
^^^^ Try Leuchte23SL HLC10Dimmwert smallest= 1 and maximum = 127 (only for LED) If you want max illumination - try Leuchte23SL HLC10-Lichtfunktion B 23 > Parklicht links (beidseitiges Parklicht aktiviert li & re) For this you don't need to add a Dimmwert setting - because Leuchte23SL HLC10-Dimmwert AB 23 will be already set to 127) If you want a smaller illumination, add my Leuchte-commands to Leuchte23SL HLC10-Lichtfunktion C 23 and Leuchte23SL HLC10-Dimmwert CD 23Don Which part of the taillights do Leuchte23SL HLC10-Lichtfunktion C 23 and Leuchte23SL HLC10-Dimmwert CD 23 control?
I'm assuming one is left and the other is right taillight.
|
|
|
|
Post by dv52 (Australia) on Jan 22, 2022 20:59:21 GMT
lordnikon: this is a very old thread - let's start from the beginning: what do you want to do? Are you from USA? Do you have LED tails? Are your tails factory fitted? Don
|
|
|
|
Post by lordnikon on Jan 23, 2022 0:32:30 GMT
Hi Don,
I have a NAR spec MK7.5 Golf GTI. I retrofitted euro taillights with rear fog functionality (LED tails without dynamic indicators) They don't have any side marker lights.
I want to enable single side parking lights (SSPL) and was wondering what coding I should do to mimic the exact function of SSPL function of ROW MK7.5 Golfs from the factory.
|
|
|
|
Post by dv52 (Australia) on Jan 23, 2022 22:05:21 GMT
lordnikon : OK - then the task is very much as I explain below: ^^^ For Single side Parking Light (SSPL): in the BCM (@ address hex09) - make sure that Driving light and parking light-Parklicht ueber LSS aktiviert is set to One-sided Then pick which lamps you want to operate as SSPL and add these commands to the associated Leuchte-set: Left side lamp Lichtfunktion > Parklicht links (beidseitiges Parklicht aktiviert li & re) Dimmwert > choose a low illumination level (for halogen lamps - suggest 31) Right side lamp Lichtfunktion > Parklicht rechts Dimmwert > choose a low illumination level (for halogen lamps - suggest 31) The only complication that may be a problem is identifying which lamp applies to which Leuchte-set. If you have retrofitted new tails, it's likely that you have altered the Leucht-set allocations - I'm not sure? Don
|
|
