plaver
Junior Member
Posts: 74
|
Post by plaver on Nov 24, 2019 8:08:14 GMT
Hello, does anyone know how to configure Activate at home and leave home without a light sensor?
|
|
|
Post by dv52 (Australia) on Nov 24, 2019 22:42:40 GMT
plaver: Hi. Without a light sensor, it isn't possible to enable Leaving Home (LH), but it is possible to enable Coming Home (CH) by setting the channels below in the Central electrics module @ address hex09 like this: If you want to enable LH, either install an OEM Light sensor, or buy a "Chinese" light sensor that piggy-back plugs into the rotary light like THIS. But if you do buy one of these "Chinese" sensors, the turn-on procedures will be determined by the sensor manufacturer's instructions. Don
|
|
plaver
Junior Member
Posts: 74
|
Post by plaver on Nov 25, 2019 6:16:12 GMT
Thank you very much, always so kind in your answers.
|
|