|
|
Post by billsy on Sept 22, 2016 12:57:16 GMT
Tear wiping
Central electronics
Byte 14
Bit 4
Mirror heating with rear window
Central electronics
Byte 15
Bit 3
Auto-unlock with removal of key
Central electronics
Byte 0
Bit 3
Auto lock above 15km/h
Central electronics
Byte 0
Bit 4
Selective locking
Central electronics
Byte 0
Bit 0
Relock after 30 seconds
Central electronics
Byte 4
Bit 5
Acoustic locking and unlocking
Central electronics
Byte 5
Bit 1 (for locking)
Bit 4 (for unlocking)
Emergency lights when braking
Central electronics
Byte 12
Bit 3 (turn signals)
Bit 4 (brake lights)
Adaptions
Staging (needle sweep)
Instruments
Confort turn signals (1 to 5 flashes)
Central electronics
Adaptions
Channel 43
Values 1 to 5
|
|
|
|
Post by Iexa200 on Dec 24, 2016 9:00:23 GMT
Tear wiping Central electronics Byte 14 Bit 4 Mirror heating with rear window Central electronics Byte 15 Bit 3 Auto-unlock with removal of key Central electronics Byte 0 Bit 3 Auto lock above 15km/h Central electronics Byte 0 Bit 4 Selective locking Central electronics Byte 0 Bit 0 Relock after 30 seconds Central electronics Byte 4 Bit 5 Acoustic locking and unlocking Central electronics Byte 5 Bit 1 (for locking) Bit 4 (for unlocking) Emergency lights when braking Central electronics Byte 12 Bit 3 (turn signals) Bit 4 (brake lights) Adaptions Staging (needle sweep) Instruments Confort turn signals (1 to 5 flashes) Central electronics Adaptions Channel 43 Values 1 to 5 |
|
|
|
Post by chrisba95 on Feb 18, 2017 1:27:10 GMT
Hello there, i have a fabia 2010 but before the facelift is it good if i use the 2010-2014 segment ?
|
|
|
|
Post by Crazy01 on Mar 10, 2017 13:08:26 GMT
Ich komme nicht in das Bremsensteuergerät. Dies ist immer schwarz dargestellt. Sowieso werden nur drei von 11 Steuergeräte erkannt.
|
|
|
|
Post by Baysun on May 24, 2017 6:59:34 GMT
Hi,
I have skoda fabia and I am using mirrorlink. But problem Mirrorlink don't work durring the drive. It works fine when I park the car. I want to use it during the drive. Is it possible with this interface ?
|
|
|
|
Post by bendarevan on Jun 2, 2017 13:31:25 GMT
This was tested by me on Skoda Fabia 5J (MY 2008).
Always do a backup of original values (just for sure)!
--------------------------------------------------------------------------------------------
CENTRAL ELECTRONICS (09)
CODING
+00001 = Trailer Hitch installed
+00002 = Trunk Lid Remote Unlocking installed
+00004 = Electric Load Management active
+00008 = Interior Light Control
+00016 = 4-door Chassis
+00032 = Heated Front Seats installed
+00064 = Heated Front Windshield installed
+00128 = Heated Mirrors installed
+00256 = Headlight Washers installed
+00512 = Rain Sensor installed
+01024 = Trunk Lid Remote Unlocking impulse driven
+08192 = Rear Windshield Wiper with Comfort Function installed
+16384 = Electric Fuel Pump Releay installed
The coding is the sum of the individual options, so if your coding is "09358",
you have code for Trunk Lid Remote Unlocking installed, Electric Load Management active,
Interior Light Control, Heated Mirrors installed, Trunk Lid Remote Unlocking impulse driven,
and Rear Windshield Wiper with Comfort Function installed.
ADAPTATION
Channel 01: Terminal 30G
(Interior Power Supply Discharge Protection)
Terminal 30G cuts the power to prevent discharge of the vehicle
battery when the interior lights are left on and ignition switched off.
Range: 1-253 (1-173 min)
Standard: 44 (30 min)
Channel 02: Front Windshield Heating Activation Time
Range: 1-253 (1-173 min)
Standard: 29 (20 min)
Special: 254 (infinite)
Channel 03: Mirror Heating Activation Time
Range: 1-253 (1-173 min)
Standard: 29 (20 min)
Special: 254 (infinite)
Channel 04: Rear Windshield Heating Activation Time
Range: 1-253 (1-173 min)
Standard: 29 (20 min)
Special: 254 (infinite)
Channel 05: Trunk Lid Remote Unlocking
Range: 1-253 (0.32-81.6 s)
Standard: 3 (1 s)
Channel 06: Comfort Blinking (Cycles)
Range: 1-5
Standard: 3
Channel 07: Teardrop Wiping
Range: 0-255 s
Standard: 5 s
(working even if the car is NOT in motion)
Channel 08: Headlight Washer Activation
Range: 0-255 s
Standard: 5 s
If you set "0", the function is disabled.
Channel 09: Rear Windshield Heating
0 = Normal Functionality
1 = Advanced Functionality
--------------------------------------------------------------------------------------------
INSTRUMENTS (17)
CODING: ??XXX
+00 = no extra options
+01 = Brake lining wear announcement
+02 = Seat belt warning
+04 = Wiping water level warning
+16 = Shows open doors in MFA
--------------------------------------------------------------------------------------------
STEERING ASSIST (44)
CODING: XXX?X
Range: 1-5 (1 = light, 5 = heavy)
Standard: 4
--------------------------------------------------------------------------------------------
COMFORT SYSTEM (46)
CODING
+00001 = Selective Locking inactive
+00002 = 4-Doors
+00016 = Central Locking installed (from MY 2008)
+00016 = Central Locking without Power Windows installed (through MY 2007)
+00064 = Central Locking with 2 Power Windows installed (through MY 2007)
+00256 = Central Locking with 4 Power Windows installed (through MY 2007)
The coding is the sum of the individual options.
ADAPTATION
Channel 03: Auto Lock
Lock speed exceeds 10mph/15kph
0 = disabled
1 = enabled
Channel 04: Auto Unlock
Unlock when key is removed from ignition
0 = disabled
1 = enabled
Channel 05: Unlock, horn sounds
Activates/de-activates unlocking "chirp" or "bleep"
0 = disabled
1 = enabled
Channel 06: Lock, horn sounds
Activates/de-activates locking "chirp" or "bleep"
0 = disabled
1 = enabled
Channel 07: Unlock, turn signals flash
Activates/de-activates unlocking indicator flash
0 = disabled
1 = enabled
Channel 08: Lock, turn signals flash
Activates/de-activates locking indicator flash
0 = disabled
1 = enabled
-------------------------------------------------------------------------------------------
|
|
