|
|
Post by daveasp1 on Aug 6, 2018 10:20:45 GMT
Morning I have recently upgraded to the Discover Pro 9.2 setup. Got pretty much everything working apart from the driving mode button. It just flashes when pressed. Its not a retrofit or anything like that and came from the factory installed so I know its not a wiring or other issue. I only have OBDeleven but found some information on coding on another site using the VCDS. These are the screenshots to enable the functionality but hoping someone can point me in the right direction to do the below using OBDeleven? Thankyou  |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 6, 2018 14:15:44 GMT
Morning, Don't know your car but this is what i would do on mine.
Connect to our car, select control unit 09 - BCM Or in OBD11 Speak Control Unit 09 (central electronics)
Select Long Coding (select option 1 if you have 0 and 1 at the top of the screen
Select Byte 15 (using the left and right arrows at the bottom of the screen
Then select Bit 5 and or Bit 7 subject to what you are supposed to have turned on
Save using the Green tick box
Then
Select Control unit: 19 Gateway
Then Long Coding (as above) and select Byte 8 and then tick the relevent bits (as described on your VCDS Screen). Please not some of your bits may already have descriptions added by a previous member
Then use the green tick to save
Now select byte 12 and tick or untick bit 2 as required.
Then use the green tick to save.
Leave obd11 and changes should be done.
|
|
|
|
Post by daveasp1 on Aug 7, 2018 7:26:24 GMT
Thanks its a Passat B8 190 rline
I followed the instructions to the letter but everything was already emabled
Hmmm
|
|
|
|
Post by snoozedoggydog on Jan 6, 2019 13:24:36 GMT
Did you ever resolve this? I've had a mib 2.5 and disc pro retrofitted in my MK7 and now the driving modes have gone. I press the button and nothing happens. Thanks Morning I have recently upgraded to the Discover Pro 9.2 setup. Got pretty much everything working apart from the driving mode button. It just flashes when pressed. Its not a retrofit or anything like that and came from the factory installed so I know its not a wiring or other issue. I only have OBDeleven but found some information on coding on another site using the VCDS. These are the screenshots to enable the functionality but hoping someone can point me in the right direction to do the below using OBDeleven? Thankyou |
|
|
|
Post by ofektal8 on Jan 31, 2019 19:31:28 GMT
If the coding is ok, then you might want to check if the Shop who performed the FeC Swap did it correctly and did infact upload the driving modes FeC.
I do not have driving modes in my car but if im not mistaken when driving modes is enabled in your car you should see the driving mode on the top left of your screen, if its there then i bet its a wiring or coding issue.
|
|
|
|
Post by tiguansunroof on Feb 1, 2021 7:47:01 GMT
good morning I made an updated gateway firmware 19 and engine 01. I have a tiguan 2016 4 motion with driving mode and land mode. The modalira in the discovet pro at the top left is written Normal. But the drive mode rotor lights up but doesn't react. How did you solve it?
|
|
