Towbar coding conversion from ODIS to OBDeleven.

Hi everyone,

I'm in the process of fitting the dedicated wiring loom to my Leon Mk3 FR and need some help with the programming side of it. I have already tried to do the coding and connect the extra module into the cars can-bus system but it came up with all sorts of errors when I powered the car back up so disconnected the additional wiring loom from the car. With the instructions for the wiring loom it has a page for doing the program changes using ODIS, I of course have OBDeleven so the layout/descriptions are different. I'm just wondering if anyone has cross referenced these options and successfully used OBDeleven to enable the tow-bar wiring. I've added a copy of the text in the manual below if someone could help I would be most grateful.

Coding with ODIS - Manually OFFLINE
Please note:
The procedure described below to configure and enable trailer mode settings, is based on a comprehensive number of control units that may be installed in the vehicle. Please check using your diagnostic equipment, what control units are actually installed.

NOTE! After connecting to ODIS, please ensure the "Trailer Function 69" controller has been enabled first

The following may be necessary in the further course of work:

Coding ECE_09 (Electronic Central Electrics):
Diagnosis
   Networking plan
      Controller self-diagnosis
         Encode
Trailer connection device        Installed
or: hitch_ecu                        Installed

Coding ZKS_46 (Central module convenience system):
Trailer monitoring                  put on active
Trailer control unit                 Installed

Encoding SWA_3C (Lane Change Assist)
ECU for draw bar                   With ECU for draw bar

Encoding SCH_17 (Dash panel insert)
Trailer                                   Yes

Encoding RFK_6C (reverse camera system)

Equipment_ahk                      Installed

Encoding STF_74 (chassis control system)
Trailer                                    Installed

Encoding EPH_76 (PDC controller)
Trailer                                    Trailer device can be removed manually

Encoding DIS_13 (controller distance control)
Control module for
towing sens                             Installed

Encoding FFF_A5 (front sensor system controller)
AAG                                        Coded

Encoding HDE_6D (boot lid electronics controller)
Trailer                                     Installed