|
|
Post by tmachun on Jul 8, 2018 21:39:18 GMT
I changed the rear brake pads and got a parking brake fault. The obdeleven shows the fault and clears other faults, but under the parking brake it says implausible signal and does not show any basic settings. How do I get the parking brake to retract?
|
|
|
|
Post by Thirsty on Jul 9, 2018 6:36:12 GMT
I would say you did something wrong while changing the pads.
Check if there are any plugs you've missed.
|
|
|
|
Post by romeom on Jan 10, 2020 15:10:17 GMT
Hello, new owner of 2012 touareg tdi. I too have problem with this module (53 parking brake)
Obdeleven see module when scanning, and didn't report any errors.
Problem is I cannot do backup (all other modules succesfully backup), and if I go to basic setting, output test or adaptation program crash or freeze.
Does anybody else have this symptoms, or is something wrong with my module.
Device is nextgen pro version.
53 Parking Brake
Opis sustava: EPB
Broj software-a: 7P0907801F
Verzija software-a: 1201
Broj hardware-a: 7P0907801F
Verzija hardware-a: H51
Serijski broj: A11911002C2
ODX tip: EV_ParkbA7
ODX verzija: 000006
Greške:
Nije pronađena niti jedna greška
|
|
|
|
Post by romeom on Feb 25, 2020 17:14:07 GMT
Anyone managed to do backup of module 53 parking brake?
I can't do it, on version 0.19 when i click backup say:
Ooops, something went wrong!
Can anyone confirm this?
|
|
r9guy
New Member
Posts: 3
|
Post by r9guy on Aug 20, 2020 8:56:36 GMT
Hi I have similiar issue. Unfortunately cannot fix myself. In my case I pressed out of curiosity in settings "electro mechanical parking break, erase active counter" assuming that it will reset some errors marked green. But instead it eraged all codings of the unit and I am driving with alarm.
On internet I have found long coding value, something like 02 04 02 00. I can set first and second groups. But 3rd group whatever I do it remains the same. my is currently 02 04 00 00
|
|
|
|
Post by frenchy99 on Aug 24, 2020 21:03:52 GMT
Had exact issue a week ago.
The way I resolved it is by running the bleeding test under basics settings.
If not I can give you my long code.
|
|
r9guy
New Member
Posts: 3
|
Post by r9guy on Nov 21, 2020 15:20:58 GMT
I would appreciate if you could do that
|
|
r9guy
New Member
Posts: 3
|
Post by r9guy on Nov 21, 2020 22:17:49 GMT
By the way to do full programming you need to go to output test and do break grinding. But unfortunetly that function is not yet available in OBDEleven.
|
|
