|
|
Post by jackycheung328 on Jun 23, 2018 1:11:35 GMT
Hi all,
I have tried to activate the needle sweep from the dashboard module, but nothing happens after the activation.
What have I missed? I did
Control Unit 17
Byte 1 bit 0
Thanks
Jacky
|
|
|
|
Post by Thirsty on Jun 23, 2018 6:07:27 GMT
The coding is right.
Have you tried switching your ignition from off to on a few times?
|
|
|
|
Post by vwjap on Jun 23, 2018 8:08:14 GMT
It doesn’t work if you just switch off your ignition, you have to switch it off, key out, let the car “go to sleep” then switch it back on again
|
|
|
|
Post by jackycheung328 on Jun 27, 2018 0:25:13 GMT
It worked sometime .... It's quite strange...
If I close the door and wait until the opening graphic finish rolling (the VW logo and then the animation for the guages rolling out), it would not do the sweep. If I start the car right away without waiting, it will sweep....
|
|
|
|
Post by nightcrawla on Oct 21, 2019 14:44:54 GMT
Trying to do this on my 2018 Passat R-Line NMS doesn't activate the needle sweep for me. Instead it activates a "brake" light on the dash followed by another warning in the center info display in big red letters saying "BRAKE WEAR" "Check brake wear!" Any Ideas?  |
|
|
|
Post by radubichis on Nov 1, 2019 10:33:43 GMT
Hello guys
I have the following error codes at Passat B8 from 2018
B1528F1 - Headlight beam adjusting motors Invalid activation voltage
Intermittent
U112600 - Undefined control module No communication
Intermittent
Can you help me solve them?
Radu
|
|
|
|
Post by danidasanic on Jul 9, 2023 21:21:31 GMT
Did you solve the first error ?
|
|
