s1ack
New Member
Posts: 6
|
Post by s1ack on May 8, 2016 19:31:41 GMT
So I removed the indicator / button pod in the dash. I applied tape to the amber, too bright LEDs that annunciate 'Passenger Airbag Off'. In the process, I turned on the ignition while the bulb intermittently disconnected from the harness.
Now I have...
Trouble codes:
B101614 - Frt.pass. side airbag disabled indicator lamp Open circuit/short circuit to ground
Intermittent
Malfunction frequency counter: 1
Date: 2016-04-23 14:16:57
Mileage: 1249 km
Unlearning counter: 255
Priority: 2
Trying 'Reset' from within this module... Hard Reset: reports success. Key off on reset: reports success Soft reset: says function not available.
So then I think this DTC can't be cleared without security access.
I tried the following security codes....none work....
31347 25327
20103
Anyone know the code for Airbag module (15)? Before I spend money for the service manual (assuming it's in there).
|
|
s1ack
New Member
Posts: 6
|
Post by s1ack on May 8, 2016 19:46:59 GMT
Nevermind....figured out what the trashcan was for. 'Reset' in my line of work is exactly what we call clearing faults.
|
|
|
Post by harvinder on Aug 10, 2024 18:31:28 GMT
Hi, I have the same issue. How do I clear the fault code? Which module do I need to go into? Do I need security access, if so what is the pin?
TIA
|
|