|
|
Post by nyogtha on Dec 29, 2017 21:23:37 GMT
Howdy! I just bought a second hand Columbus (rns510) for my Skoda Fabia 2013 (mk2 facelift) vrs. I need to enable navigation in the equipment list, but I don’t have the little pencil icon that allows me to change installed equipment. I think the pre-facelift fabias used canbus protocol version 1.6 which would lead to this problem(?), but the facelifted versions should be using 2.0. Any ideas?
|
|
|
|
Post by nyogtha on Dec 30, 2017 14:06:06 GMT
Here's my Gateway info and also the module screen where you can see there's no icon for editing the equipment list:   |
|
|
|
Post by nyogtha on Jan 4, 2018 7:51:34 GMT
I fixed this with VCDS and made a more general topic in the Fabia 5J section. This can be closed, thanks  |
|
|
|
Post by mindhunter on Aug 20, 2020 10:02:09 GMT
Hi i have the same problem butt i dont have a vagcom cabble i can not make the changes someone a idea
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 20, 2020 16:08:43 GMT
If you mean equipment list as in the equipment that is shown on the sticker fitted to your car then. Log on to OBD11 Select your car (if you have multiple cars) This will show you the My Car screen. Select Info You will then see the Vin, Year Body Type and Mileage Under that is Engine which shows the Engine code and power Then the Equipment list Use the Black pencil to enter codes.
If you mean you are missing Control units then you can add in missing ones or use the Auto Code process to ensure they are all show.
Some control units are listed as subsystems, if you are missing some of these then contact support and see if they can help
hope that helps. |
|
|
|
Post by silly1 on Aug 21, 2020 15:03:02 GMT
I have seen this happen occasionally on the gateway list icon or charts save icon.
if you scroll down then up again on the screen, it sometimes causes a refresh and the icon then appears
|
|
