d3rf
New Member
Posts: 2
|
Post by d3rf on Oct 5, 2024 21:47:14 GMT
Hi there, Mk8r Owner. I trying to log timing correction and i dont understand why i have only cylinder 1 and not others on the apps (available on others plate-forme, vcds etc). Capture for exemple. ![]()  |
|
|
|
Post by dv52 (Australia) on Oct 5, 2024 23:42:01 GMT
Hmm......... I'm not sure why you are "trying to log timing correction" - but I suspect that the ignition timing adjustment cylinder 1 entry in your picture is NOT relevant to your quest. My guess is that the cylinder 1 entry is telling you about Top-Dead-Center - it's not relevant to "timing correction".
I don't have this engine, but try searching for other terms like "retardation", or just "cylinder" - you should pull-up Timing angle retardation for each cylinder #.
Don
|
|
d3rf
New Member
Posts: 2
|
Post by d3rf on Oct 6, 2024 9:27:03 GMT
Thanks Don for your answer. I'm trying to log my car to check ignition et fueling. In my obdeleven garage i have TTS Gen3 2.0TFSI and my MK8R Gen4 2.0TFSI...New ECU and maybe different chanel log. Here my mk8r results for "Cylinder" entry :  And for the TTS 8S gen 3 with same entry :  Two options, obdeleven didn't have all log Chanel or there is différent way to log but i'm more on the first option... |
|
|
|
Post by dv52 (Australia) on Oct 6, 2024 21:42:56 GMT
d3rf: hmm......... OK. I suspect that we are both referring to the same thing - albeit we are using different terms My guess is that you are using the word "correction" to mean the positive/negative variation in the timing angle of the camshaft position. And the nomenclature that VW's ECU uses in Live Data is the term "retardation" (again, positive/negative) to describe the same ignition timing angle.
Don
|
|
