|
|
Post by doublec4 on Sept 24, 2017 0:24:10 GMT
Hello,
I just installed new central control unit and I need to adapt my remotes again.
How can I do this with OBDeleven?
Thank you
|
|
|
|
Post by doublec4 on Sept 24, 2017 15:16:14 GMT
So I found it in module 46, channel 001
But it won't let me program the remotes. When I put a value of 2 in (for two remotes) it will not accept it, and even if I put 1 in and I hold the green check mark, it accepts the code but I cannot program my remotes. Pressing the button on the remote does not sync it with the vehicle.
Any help from obd eleven?
|
|
|
|
Post by doublec4 on Sept 24, 2017 18:39:02 GMT
Okay... so here is what I had to do...
Go to channel 000 first, hit factory reset.
Then go to channel 001, it won't let you enter a value of 2 (at least on mine), so re-enter "1" , hold the green check mark and once accepted press the unlock button on your fob. The second fob won't work at this point like in VCDS
Re-enter the value "1" again, hold the green check mark and then do hit unlock on your second fob. Both should work now...
|
|
