|
Post by wb1983 on Jan 29, 2024 18:13:24 GMT
Hi all, So I purchased my OBDEleven and it got my rear view camera working brilliant. In fact, al I had to do was fire up OBD11 and it autodetected my camera and I didn't have to change any settings, great! But I do have this one issue, the picture is wonky.... the seller says it needs calibrating. I don't care if the guidance lines and the blue display don't work, but I would like an level display. Would calibration allow the image angle to be adjusted? And what setting in the 16 options would do that? Thanks!
|
|
|
Post by dv52 (Australia) on Jan 29, 2024 21:12:30 GMT
hmm......... "wonky" ain't a technical term that has a common meaning in different parts of this fragile blue planet (and across different folk)!!
Maybe add a few more words to describe the problem - it isn't clear (to me) from your picture! Also, it would be helpful to also provide more specific information about the retrofit project. Which particular camera did you install? What specific model A3 is this car? What country?
And whilst it might have been "great" that you "didn't have to change any settings" - this doesn't mean that the settings are compatible with the car. In fact, a typical High-line RVC (I assume that you didn't install a Low-line RVC) has 88 x separate software switches in its long-code string. It would be a low probability for every-one of these software switches in the new module to EXACTLY match the needs of your car (albeit there is a finite chance that they would match).
So, while you are providing the added information requested above - perhaps add a copy of the long-code string for the new 6C module (again assuming that you fitted a high-line RVC)
And finally - are there any errors post-retrofit in the SCAN report for this car?. If so, provide a copy of the SCAN - please
Don
|
|
|
Post by wb1983 on Jan 29, 2024 21:46:00 GMT
It's in a 2017 S3 and it's the highline model.
I mean wonky as in level. Have a look at the attached photo, The pavement and window sill of the house are down on the right hand side, everything is on a slope.
There are no errors or faults showing when doing a scan before or after coding.
The picture on everything appears to be tilted by about 10 degrees.
I'll grab a scan next time I'm in the car.
|
|