quier
New Member
Posts: 2
|
Post by quier on Dec 6, 2023 19:30:28 GMT
Hi, i have a problem with my id3. I have a b1802f1 dtc and it's comming back after I clear it. I assume that my 12v battery is dead. I checked and there is no options for coding/adapting new battery. Is it so easy to just replace it? Did anyone had such case or replaced battery by themself?
|
|
papad
New Member
Posts: 13
|
Post by papad on Dec 6, 2023 20:35:58 GMT
Well, I've let go of the Battery while installing speakers in the rear doors. Loosen minus first, I've been told, but no clear explanation why. Install with minus last. Lots of errors afterwards, which clears by itself after two or three runs. But if the battery is dead in you, I don't think you'd be able to do anything. Not even reading codes.
|
|
quier
New Member
Posts: 2
|
Post by quier on Dec 7, 2023 18:31:24 GMT
12v battery is ok enough. After unlocking SFD protection it was possible to do adaptation of a battery in the gateway. After that it was possible to clear dtc.
|
|