local
New Member
Posts: 2
|
Post by local on Aug 28, 2023 16:31:05 GMT
I have a 2022 SQ5 with matrix LED auto leveling headlights.
I installed the ABT HAS (height adjustable suspension kit) and dropped my car about 40mm on all sides. Despite spending all night adjusting the little bars that tell your sensors the state of your vehicle (so it can adjust headlights for having extra weight in your trunk, etc) my headlights are still pretty damn low - like my car thinks I have 1,000 pounds in my trunk and has adjusted my head lights down so I don't blind other other people.
I found out that to adjust matrix headlights you need to put them into service mode first.
I looked through obdeleven and at the bottom of my control units list I see matrix left and matrix right - as two separate controls - but from the images it seems to say those control the ability of the lights to point to the side.
So two questions -
1. How do I put my general headlights into service mode to adjust them back to level?
2. Is it possible to code my headlights so when I turn left or right at night the left or right outside light comes on? Like when you press the bad weather light button and they both come on allowing you to see farther out to your left and right side?
Regards,
|
|
local
New Member
Posts: 2
|
Post by local on Aug 28, 2023 17:08:17 GMT
Apologies I have LED headlights but not matrix headlights
|
|
|
Post by jcgonzalezcolon on Nov 26, 2023 2:45:14 GMT
I used M6 full threaded rods (130mm) and end ball bearings with studs (M6x1.0) to recreate the factory height sensor rods. Bought all on Amazon for about $40. Easy DIY no cutting or anything. Just remove the factory (plastic) rod and replace with one you'd make with rods and bearings. Hope this helps
|
|