|
Post by trauma1031 on Aug 19, 2023 18:12:55 GMT
My AC is blowing hot air and when I scan the vehicle I got an A/C compressor first run was not performed error. I went and performed the adapt flap end stops in basic settings and after that, the compressor run in, automatic start adaptation, I got the marginal condition has not been met error. After performing that task. I'd been searching for a solution and didn’t find anything. Did someone know how to fix this issue?
|
|
|
Post by trauma1031 on Aug 20, 2023 12:08:57 GMT
Problem fixed
|
|
|
Post by ryan7926 on Aug 28, 2023 5:16:57 GMT
For the benefit of other users who might encounter the same problem it would be good to post the fix that worked for you.
|
|