|
Post by benytughgh on Jun 15, 2023 21:24:24 GMT
Hi People,
Im doing an ATF/MTF fluid change on my diff. Need need to bleed the system afterwards.
ODIS procedure - "go into module 22 "Four Wheel Electronics" and select function 22 "Adding ATF""
VCDS procedure - "1. Ignition ON / Engine OFF / Battery Charger connected 2. Security Access (see VCDS) 3. Basic Settings > Reset oil-aging adaptation values (IDE03677) 4. Security Access (see VCDS) 5. Output Test > Fill Pressure Lines (IDE03345) Check Meas. Values for max. Pressure (should reach ~2 bar) Oil pressure and oil temperature sensor, pressure (G437/IDE02035) Oil pressure and oil temperature sensor 2, pressure (G640/IDE02036) 6. Security Access (see VCDS) 7. Output Test > Bleed Pressure Lines (IDE03439) Check Meas. Values for max. Pressure (should reach ~20 bar) Oil pressure and oil temperature sensor, pressure (G437/IDE02035) Oil pressure and oil temperature sensor 2, pressure (G640/IDE02036)"
Is there a way to do this with my ODBeleven?
Thanks in advance
|
|
|
Post by nunodinis on May 15, 2024 14:39:51 GMT
Hello
Just checking if you managed to get the info below. I'm planning to service the rear sport diff on my RS4 (2014) but I also need to replace one of the Oil and Pressure Sensors which isn't reading any pressure.
I would also be interested in knowing how to do the sensor adaption using OBDEleven.
Thank you
|
|