|
|
Post by meadows01736 on May 3, 2023 21:59:49 GMT
Just purchased the Pro software now I'm getting a GATEWAY 19 DATA BUS additional installations detecte fault code
Can't clear it.
What do I do here.
Obd has only ever found 17 control units
Should it be finding 19 ?
|
|
|
|
Post by dv52 (Australia) on May 4, 2023 0:19:39 GMT
meadows01736 : Hi. Assuming no OBD11 software error and based purely on the scant information provided - I suspect that there is a mismatch between the modules that have been registered on the CAN network for this car in the Gateway Installation List (GIL) and the modules that are actually installed in the car. For the CAN system to operate correctly in diagnostic mode, the two must be the same and when the car left the VW production line - the two were the same!!
So - because of the way that the GIL was populated when this car was built - it maybe that somehow changes have been made to the GIL in the intervening period (I assume that you haven't added any new modules). If you are using Android, you can automatically restore the GIL by activating AUTOCODE - see instructions below from whataboutthis : 1/ From the Main menu select Settings
| 2/ From Settings Menu ensure Autocode Gateway List is set to show, if not change it to show
| 3/ Connect to car and you should get the following popup box , Select Yes and any missing control units will be ADDED
|  |  |  |
If you are using iOS, you will need to restore the GIL manually.
To do this, look at the Control Units screen (i.e. the first screenshot below) and in particular - notice the color surrounding the module number
Modules that are properly registered in the GIL will have either green (no module faults), or red (module faults present) coloring. Incorrectly registered modules in the GIL will have a yellow (module installed but not registered), or black (module registered, but not installed) coloring
To fix - follow the steps below (add tick to the missing module IDs in the last screenshot):
Don
|
|
