|
Post by kcurpen on Apr 19, 2023 13:51:34 GMT
Hi, Anybody has retrofitted the antitheft alarm system. I have installed the hardwares as follows
-Interior monitoring sensors + Inclination sender -Siren -Antitheft deactivation switch (on driver's door)
I now need only the codings to enable the alarm system, would be grateful if you can assist. Thank you.
|
|
|
Post by andreabafile on May 20, 2023 21:47:36 GMT
Hi, yes did it on A5 B9.
The coding it's easy, you do everything on the controller 46 - comfort:
LONG CODING - Theft Alarm System: installed - Interior Monitor sensor: installed - Tilt sensor. Installed - Theft Alarm System with simple horn: Sounder Installed - Theft alarm tamper alarm: Ten tamper alarm - Horn acknowledgement: active - Warning tone open alarm contact: active
ADAPTATIONS: Sounder settings -> here you choose, I just recommend you select "frequency modulated" as sound.
You can skip the installation of the deactivation switch if you want, is not essential.
|
|
|
Post by kcurpen on Aug 15, 2023 11:06:35 GMT
Hi Thanks for your reply, Will give this a try.
Have installed and wired the antitheft module, Siren and Deactivation switch.
|
|
|
Post by kcurpen on Aug 15, 2023 11:17:15 GMT
To enable the "Tone when Locking" option in the MMI under Car / Vehicle Settings / Central Locking
Try this Controller 46
Long coding for Byte 4
Select/Tick "Bit 6"
|
|
|
Post by peppecleo on Sept 9, 2023 0:26:59 GMT
hi, do you have the serial number of the tilt transmitter?
|
|
|
Post by peppecleo on Sept 9, 2023 13:29:12 GMT
Hi, Anybody has retrofitted the antitheft alarm system. I have installed the hardwares as follows -Interior monitoring sensors + Inclination sender -Siren -Antitheft deactivation switch (on driver's door) I now need only the codings to enable the alarm system, would be grateful if you can assist. Thank you.
|
|
|
Post by peppecleo on Sept 9, 2023 13:29:24 GMT
hi, do you have the code for the Tilt Transmitter
|
|
|
Post by kcurpen on Sept 22, 2023 4:14:22 GMT
Hi here are the codings
LONG CODING
- Theft Alarm System: installed
- Interior Monitor sensor: installed
- Tilt sensor. Installed
- Theft Alarm System with simple horn: Sounder Installed
- Theft alarm tamper alarm: Ten tamper alarm
- Horn acknowledgement: active
- Warning tone open alarm contact: active
you notice, coding in red is for the tilt sensor. don't think there are other codings specific for the tilt sensor
|
|
|
Post by andreamap on Apr 27, 2024 12:41:19 GMT
Hi, Anybody has retrofitted the antitheft alarm system. I have installed the hardwares as follows -Interior monitoring sensors + Inclination sender -Siren -Antitheft deactivation switch (on driver's door) I now need only the codings to enable the alarm system, would be grateful if you can assist. Thank you. Do you have the wiring diagram for the retrofit? Where did you buy all the stuffs?
|
|