|
|
Post by Big tex on Jun 25, 2017 19:10:38 GMT
I lowered by 2017 S6 and my headlights no longer self adjust on startup. I found instructions on how to reprogram them to do so, but I need access to module 55. I added the module, but when I try to access it it is not responsive. Any ideas?
|
|
|
|
Post by Big Tex on Jun 27, 2017 12:37:48 GMT
As a followup to my prior post, the support team informed me that on the post face lift models control unit 55 is integrated into control unit 9 for U.S. models. I thought I would post that information here in case it may help someone else.
Later this week I will see if I can make the necessary adjustments in control unit 9 to get my headlights to auto level again, as right now after lowering my car my headlights are in a fixed position. However, the instructions I have utilize control unit 55 in this regard, and likely will not be the same for control unit 9. Once I figure out the process for control unit 9 I will post the process on this forum. In the interim, if anyone has had success making adjustments to control unit 9 in this regard kindly post the process used.
|
|
|
|
Post by phantoma6 on Aug 27, 2017 17:01:32 GMT
Great work and support for the team but do watch out for the fact that 17+ cars have different assignments for everything. We just bought a 17 Q5 and the coding info floating around for Q5 although are similar, I have found to be different in certain modules.
|
|
|
|
Post by a2andres on Mar 23, 2022 18:08:20 GMT
Brining this thread back from the dead because I am in a similar situation. I have a 2017 SQ5 that I recently lowered and went into the OBDEleven - Module 9 - Basic Settings - Channel 11 - which takes you to the ability to put the car in headlight adjustment mode. The car seemingly brought the headlights up - I did NOT touch any of the manual adjustments screws.
On iOS there is a slide bar that is green that you slide to I assume put the car in "adjustment mode" then a slide bar that says "stop adjustment" I let the car bring the headlights up and then slid the red "slide to stop" BUT now I get an error message every time the car is turned on. Fault Code is 01539 - Headlight not adjusted. There is also a warning light in the dash and beep that occurs whenever the car is turned on.
Anyone figure out what to change in module 9 that used to be done in module 55?
|
|
