Post by davidapollo on Dec 27, 2022 22:30:15 GMT
Hello there, I was wondering if anybody could help me out here. I'm pretty new to OBD11 so I apologise in advance if there is any confusion on my part.
When I tick the box on my menu with the DRL setting. My Light switch in my car is on the 0 setting.
Now here is where my issue persists;
The low beam headlights pop up, rather than the DRLs which then gives me a fault on the dash saying
"Check LEFT DRL"
"Check RIGHT DRL"
This is because, I'm using common sense, the lowbeam light is on, rather than the DRL itself.
I have previously coded in AUTO, where I wanted DRL's to be activated 100% with lowbeam, so maybe the issue lays here?
Hope someone can help.
The picture shown below is with the DRL menu ticked and my headlight switch on 0
Love from Ireland
When I tick the box on my menu with the DRL setting. My Light switch in my car is on the 0 setting.
Now here is where my issue persists;
The low beam headlights pop up, rather than the DRLs which then gives me a fault on the dash saying
"Check LEFT DRL"
"Check RIGHT DRL"
This is because, I'm using common sense, the lowbeam light is on, rather than the DRL itself.
I have previously coded in AUTO, where I wanted DRL's to be activated 100% with lowbeam, so maybe the issue lays here?
Hope someone can help.
The picture shown below is with the DRL menu ticked and my headlight switch on 0
Love from Ireland
