|
|
Post by Jacob C on May 13, 2017 11:54:32 GMT
Hi All, I have just noticed an error pop up when scanning my car, and for some reason, I cannot clear the fault by holding down the big circle like normal. Any ideas or ways to solve this fault? Drive a 2014 Audi S3 if that helps  Cheers, Jacob |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 13, 2017 12:43:30 GMT
According to the app error codes beginning with C are related to Chassis (ABS, Level Control etc)
and the error I see in the lookup table is Dynamic calibration limit value exceeded.
I don't know the answer but i am guessing that the code wont clear because there is an error in one of the settings (causing the limit to exceed)
Have you made any changes.
|
|
|
|
Post by Jacob C on May 13, 2017 20:15:04 GMT
Thanks for your reply I have made some changes, however, this error code came up before I did. Is there any way to narrow down what part of the Chassis system is throwing the fault? Or is it a bit hit and miss? Cheers |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 13, 2017 22:24:19 GMT
sorry dot know. the only item i found on the web was 'C1106 Traction Control Disable Switch Circuit Short to Battery '
I Would suggest a quick mail to support to see if they can help
|
|
|
|
Post by ccosmin on Aug 12, 2018 6:48:09 GMT
Hi do you have any updates on this error? I have the same problem and HBA stopped working.
If I clear the error, it works again for 2-5 minutes before appearing again.
|
|
|
|
Post by ofektal8 on Jan 11, 2019 20:25:01 GMT
Mine too, I Retrofitted Lane assist Everything works perfectly but after driving with the feature on for 5 minutes i get this error and the camera stops working.
Please someone?
|
|
|
|
Post by ofektal8 on Feb 8, 2019 16:38:25 GMT
I got some Updates on that, if you are having this error check the live data channels for the dynamic calibration.
It shows the offset of the lane assust camera that the dynamic calibration proccess has calculated, and if the offset is too high then it cannot keep the proccess going and throws that error.
|
|
|
|
Post by ccosmin on Aug 1, 2019 17:13:50 GMT
And how can it be fixed? Did you manage to fix?
|
|
|
|
Post by ccosmin on Aug 1, 2019 19:26:48 GMT
I’ve just checked and I do not have the Dynamic Calibration under live data
|
|
|
|
Post by ofektal8 on Nov 14, 2019 13:08:22 GMT
If the offset in the live data is too high then you need to check if your camera is properly installed. And you might need to get in recalibrated.
|
|
