|
Post by Lamin on May 7, 2017 3:18:20 GMT
Hi i have a uk model golf match with standard lights i have upgraded the rear lights to (gtd) led lights. Also i have changed the bootlid to gtd bootlid with wiring. Everything works fine just the inner turn signal does not work can someome please tell me the adaption channels for the inner turn signal and the right settings for them. I assume i dont have to wire the inner signals in as i have changed the bootlid?
|
|
|
Post by dv52 (Australia) on May 7, 2017 6:37:35 GMT
Hi i have a uk model golf match with standard lights i have upgraded the rear lights to (gtd) led lights. Also i have changed the bootlid to gtd bootlid with wiring. Everything works fine just the inner turn signal does not work can someome please tell me the adaption channels for the inner turn signal and the right settings for them. I assume i dont have to wire the inner signals in as i have changed the bootlid? Lamin: Bad news - your assumption is incorrect (alas). Here's a section of the wiring diagram showing the rear left turn signal arrangement for an incandescent fitting (left of picture)and an LED fitting (right of picture) Notice that the outer lamps are connected to the same Pin on J519 (this is the module that OBD11 calls Central electric)- T73a /60 means that the lamp is connected to a 73 x pin connector on PIN #60 on the A socket. However, notice that the inner LED turn signal lamp doesn't have an equivalent pin for the incandescent fittings This means that you if you don't want any fancy turn-signal effect (like counter blinking of the two lamps),you can simply run a wire to the outer lamp (on each side). Or you can run a wire back to J519 to PIN 9 on socket C . The right side inner turn signal is connected to PIN 3 on socket C. Of course once this is done, you will need to enable the appropriate Leuchte-sets for these two pins. Don
|
|