Post by azehiel on Aug 3, 2022 12:05:30 GMT
Hey Folks,
I have scala my21 with sport chassis control - is it the same as DCC in octavia ?
Im asking because I will go lower around 30-50mm (replace springs) and I found recalibration procedure for octavia with dcc :
Any1 have knowledge about is SCC ? Is it the same as DCC ?
I have scala my21 with sport chassis control - is it the same as DCC in octavia ?
Im asking because I will go lower around 30-50mm (replace springs) and I found recalibration procedure for octavia with dcc :
the end result is a more refined "bounce" and a reduction of bottoming-out (in Comfort and Normal modes).
while the change is not night & day difference, u can certainly feel the DCC rides better now with the lowered springs.
u'll need:-
- to make sure to jack your ur up, or lift it, so that all 4 wheels are sagging fully, off the ground
- an OBDEleven tool (NOTE: this CANNOT be done with VCDS)
Go to Control Module 14 - Adaptive Suspension
Enter security code 20103.
Go to Adaptations
Select “Adapting with deflected wheels”
Take note of the values, as they should change later.
Don’t change anything, instead back out
Enter Basic Settings
Select “Adapting with deflected wheels”
Slide to Start or Press & hold Green tick to Start. It should run for a second and then say something like basic setting ended.
while the change is not night & day difference, u can certainly feel the DCC rides better now with the lowered springs.
u'll need:-
- to make sure to jack your ur up, or lift it, so that all 4 wheels are sagging fully, off the ground
- an OBDEleven tool (NOTE: this CANNOT be done with VCDS)
Go to Control Module 14 - Adaptive Suspension
Enter security code 20103.
Go to Adaptations
Select “Adapting with deflected wheels”
Take note of the values, as they should change later.
Don’t change anything, instead back out
Enter Basic Settings
Select “Adapting with deflected wheels”
Slide to Start or Press & hold Green tick to Start. It should run for a second and then say something like basic setting ended.
