|
|
Post by tylerbebbo on Apr 28, 2022 6:03:27 GMT
Hi all, just after abit of help, I’ve never really used OBDELEVEN before so I’m not 100% sure how to navigate it. Does anyone know how to code in the heated seats. I’ve used all genuine parts it’s literally just the coding left which has never been my speciality haha!
Thank you!!
|
|
|
|
Post by dv52 (Australia) on Apr 28, 2022 21:03:48 GMT
hmm....... I'm assuming that you have directly wired the the heating elements onto the pins on the central electrics module and that you refer to front seats only (and that the retrofitted seat heating does NOT use the CAN network). And, because you are posting on the mk7 forum, I'm also assuming that your hex09 module has an active long-code string.
If ALL my assumptions are correct - then the software switch that tells the central electrics module to start operating seat heating is on Byte 3, Bit 5. There are a bunch of adaptation channels in the hex09 module that control how the seating heating works - but these are normally factory pre-set - so they shouldn't need to changing
Don
|
|
|
|
Post by tylerbebbo on Jun 2, 2022 14:56:34 GMT
Okay I’ll take a look, thank you, I know on the mk6 Aw polo it was pretty simple so I was hoping it was similar as I’m new to all this and still trying to get my head around it. The polo one is below.
-control unit 09
-adaptation
-typ in: heated seat OR stoelverwarming OR sitzheitzung
-press: Sitzheitzung_CAN
set it from: not avalable
to: Seat heater on_LIN
|
|
|
|
Post by dv52 (Australia) on Jun 2, 2022 22:21:44 GMT
hmm........ not sure I understand
|
|
