|
Post by carbonchaos on Sept 18, 2021 16:45:56 GMT
Hi all, so I found some coding on the app in manuals for teardrop wiping but it doesn’t seem to work on my vehicle. heres the coding * Control unit 09 central electrics Adaptations Windshield wiper Traenenwischen front status,set to active menuesteuerung frontwischer set to active
which was all accepted ok but nothing changed in the operation of the wipers ?
what I was expecting was pull the front wash , washers and wipers operate constantly until switch is released then the wipers continue for 3 further sweeps wait a short period then wipers do 1 more sweep.
what I got was normal operation ie everything but no final sweep ?
my vehicle is a 2016 polo GTI (UK) with auto wipers with a RLS as standard does this coding only work on vehicles without a RLS ?
|
|
|
Post by maniek on Sept 24, 2021 12:04:06 GMT
hello carbon...
well i made this coding procedure for my polo 2014 and works- front and rear wipers. i do not have RLS and maybe this is a reason but maybe also your newer control unit and newer software version matters
did you try this procedure for rear wiper?
|
|
|
Post by carbonchaos on Oct 3, 2021 14:31:49 GMT
Not tried this on the rear as it has intermittent wipe anyways
|
|
|
Post by maniek on Oct 11, 2021 11:52:37 GMT
so maybe this will help: do you have in control unit 09> subsystems> 48xLL xxxxxxx if yes pls check if
byte 00> bit Bit 3 "Adaptative Post/Tear Wiping Active" is ticked
byte 02> bit Bit 5 "Post/Tear Wiping Active" is ticked
|
|