|
|
Post by martinlaitinen on Aug 7, 2021 10:01:32 GMT
Hello I can not enable Light Assist (Auto High Beam on my passat alltrack 2013 
did not my vehicle have this one ?
|
|
|
|
Post by danielr on Aug 11, 2021 5:22:50 GMT
Do you have Camera A5 ?
|
|
|
|
Post by martinlaitinen on Aug 13, 2021 8:27:57 GMT
I don´t know how do i check this ? i have Lane assist, Adaptiv Cruise Controller and Lane Change Assist  |
|
|
|
Post by danielr on Aug 16, 2021 5:48:27 GMT
Stg. A5 -> Byte 2 -> Light Assist Modus 1 (LA)
Stg. A5 -> Byte 10 -> Execution headlights: Halogen Headlight or
Stg. A5 -> Byte 10 -> Execution headlights: Xenon Headlight
Stg. 09 -> Byte 11 -> Bit 3 active (Light Assist)
|
|
|
|
Post by martinlaitinen on Aug 16, 2021 12:20:01 GMT
 I chance the coding_FLA to coded modus 1 (LA) and FLA_Headlight_type = xenon
and the Stg. 09 -> Byte 11 -> Bit 3 active (Light Assist)
is that correct ? or
did I need to change something else
|
|
ekkar
New Member
Posts: 41
|
Post by ekkar on Aug 19, 2021 5:56:51 GMT
martinlaitinen A tip from another swede, change language to english for much better coverage of describings in long coding etc. 
|
|
|
|
Post by jensberglund on Nov 2, 2021 9:52:56 GMT
Stg. A5 -> Byte 2 -> Light Assist Modus 1 (LA) Stg. A5 -> Byte 10 -> Execution headlights: Halogen Headlight or Stg. A5 -> Byte 10 -> Execution headlights: Xenon Headlight Stg. 09 -> Byte 11 -> Bit 3 active (Light Assist) Hi! I did the 3 steps you mention but when I tick Byte 11 - Bit 3 it immediately shows "Fault: Light assist" in MFD. I have the Camera A5. danielr |
|
|
|
Post by martinlaitinen on Nov 5, 2021 9:04:45 GMT
You need to chance the coding_FLA to coded modus 1 (LA)
A5 byte 2
|
|
|
|
Post by jensberglund on Nov 5, 2021 11:48:56 GMT
Yes, that is what I did.
A5 - byte 2 - (LA)
A5 - byte 10 - xenon
09 - byte 11 - bit 3
Still getting fault in MFD.
|
|
|
|
Post by martinlaitinen on Nov 5, 2021 21:51:31 GMT
Try to change coding_hca to coded
Or else try fla_additional_high_beam
|
|
|
|
Post by jensberglund on Nov 11, 2021 19:17:07 GMT
Tried that now. Did not work 😢 still getting error in mfd.
Coding_hca was already “coded” so I just coded fla additional high beam as well. So my set up was;
HCA - coded
FLA - LA
FLA additional - coded
09-byte 11 - bit 3
|
|
