|
|
Post by quartodemone on Jun 18, 2021 6:15:42 GMT
Good morning
through the application I have installed the detection of traffic signs, but I always get the error message.
I have line assist, but I don't have a navigator, someone can help me.
thank you
|
|
|
|
Post by mazinga on Jun 18, 2021 17:14:44 GMT
Hello. Me too. Traffic signs recognition anomaly tells me ... even the application coding does not work ...
|
|
|
|
Post by Trigonometer on Jun 24, 2021 10:39:37 GMT
Does not work for me either. My T-Cross is Model 2020, with navi. While coding with app, the app said something like "not successful".No credits were transfered and there is no entry in the log. But now I allways get fault message when starting car. Cannot set to default, because app does not work correctly (Check internet connection). the Internet conection is definitely ok.
|
|
|
|
Post by Trigonometer on Jun 25, 2021 11:47:39 GMT
This is how i turned back and cleared the fault message in cockpit display:
Scan for faults.
Delete all faults in storage.
Enter Module 17
Click on Extended Coding
Press the button on the top right that shows a '0' and '1' to see it Bytes mode; Each Byte has 8 bits (from 0 to 7 included)
Down, press the right arrow until you reach Byte 5
Inside Byte 5 deactivate bit 2 and do not modify the rest
Press the Validate button
Restart the Infotainment by pressing and holding the power button between 10s to 15s and release.
That seems to help.
|
|
