|
Post by fraserowen on Jun 10, 2021 8:02:28 GMT
Hi,
I am trying to install Criuse Control to my 2008 VW EOS. I have installed the Stalk and the Control Cable is fitted. When I try go to program Engine Module 01 there is no option for Coding II in the Menu.
Any Idea's?
|
|
|
Post by Thirsty on Jun 10, 2021 9:25:15 GMT
Have you checked the other coding options? Why do you think you need Coding II?
|
|
|
Post by fraserowen on Jun 10, 2021 15:53:24 GMT
A couple of guides I have read have said to open long Coding II in 01 - Engine module and set it to 11463. This is people using either ODBEleven and VCDS
I have tried Long Coding but I get an error when trying to make the change, so I assumed it had to be done in Coding II
|
|
|
Post by Thirsty on Jun 10, 2021 20:33:15 GMT
I searched a bit and found out that you activate cruise control via security access. 1) ECU 01 2) Select security access 3) Enter the one of the following codes to activate/deactivate cruise control Activate: 11463 Deactivate: 16167
This should work if you don't have a 2.0l TFSI (AXX) engine.
For AXX engine the activation is done using long coding. 1) ECU 01 2) Select long coding 3) Select Byte 06 4) Enter 01 to activate cruise control or 00 to deactivate cruise control
|
|
|
Post by fraserowen on Jun 15, 2021 21:42:31 GMT
Thanks for your help Thirsty. I will have to hunt down the login code to be enable to access it.
|
|
|
Post by Thirsty on Jun 16, 2021 6:19:35 GMT
Is the code 11463 not working?
|
|
|
Post by fraserowen on Jun 16, 2021 17:50:02 GMT
It is a 2.0l TFSI btw. No, when I open Security Access I get prompted for a Login Code. If I enter 11463 at this point I get (37) Login not possible, lock time not yet elapsed.
It take that i need to enter a login code before I can enter 11463?
|
|
|
Post by Thirsty on Jun 16, 2021 19:09:54 GMT
(37) Login not possible, lock time not yet elapsed. This tells you that you entered too many wrong login codes. You need to wait some time before you can enter codes again. If you have a AXX engine the activation is done via long coding(see forum.obdeleven.com/post/55256/thread).
|
|
|
Post by fraserowen on Jun 17, 2021 18:10:55 GMT
I tried the long coding and it is set to active but not working, no CC light on Dash so it might be the Coding II.
Oh well, I will have to investigate it further.
Many thanks for you time and help.
|
|