|
|
Post by dunbus on May 13, 2021 1:25:52 GMT
Hi,
Has anybody figured out how to code and change the front LED blinkers into dynamic running lights, if it is possible?
Thanks
|
|
|
|
Post by dv52 (Australia) on May 13, 2021 21:34:11 GMT
dunbus : Hi. When you say "dynamic running lights", I assume that you mean "daytime running lights" (i.e. DRLs). If you mean "dynamic turn signal lights", then alas it's not possible because this necessitates different physical components - extra LED chaser circuits are installed in the headlight assembly
If you meant DRLs, look at the Leuchte-set in the central electrics module called Leuchte 0 BLK VL B36 - is the Lasttyp channel value not active?
If so, the headlight fittings are managed by Light Control Modules (LCMs) and no changes are possible to any headlight lamp (including the turn-signal lights).
If not, post-up screenshots of the Leuchte-set (i.e. ALL 19 x channels)
Don
|
|
|
|
Post by dunbus on May 13, 2021 22:14:13 GMT
Thanks, Don
I meant dynamic turn signal lights yes. Do you know where to get these circuits pls?
Thanks
|
|
|
|
Post by dv52 (Australia) on May 13, 2021 23:29:26 GMT
dunbus : OK - so you meant dynamic blinkers. AFAIK (happy to be told otherwise), you can't buy the LED chaser circuits as an after-market purchase because they are integrated into the fittings (think about it - to achieve the dynamic effect, each LED in the string needs to be separately wired to the chaser-circuit so that it lights-up slightly later than its immediate neighbor. I guess if you had the electronic skills and the inclination, you could design a chaser-circuit and dismantle the headlight fitting to make the modification - but it's a complex and a fiddly job!! You need to change the entire headlight assembly - expensive exercise just to get dynamic blinkers (IMO of course) Don Don
|
|
|
|
Post by dunbus on May 30, 2021 23:40:52 GMT
Thanks a million dv52 :-)
|
|
