|
Post by ilbabis on Apr 24, 2021 20:40:40 GMT
Hello everyone! I recently purchased the touch climatronic panel from the Passat, it's a popular retrofit . The seller claimed to be a plug n' play panel , which, is partially true considering it works great .
Gives an error though, - B108B54 - Fresh air, recirculation, air flow flap motor No basic setting
I tried the flap calibration, didn't make any difference.
This panel has the "Air Care" button which apparently my car doesn't support, if that's of any help.
|
|
|
Post by dv52 (Australia) on Apr 24, 2021 21:48:06 GMT
ilbabis : Hi. I'm just guessing, but the software switches for the air flow flap motor are in long-code on the hex08 module. Specifically, these switches are on Byte 7, Bit 6-7. So, if you have access to the long-code string from the original hex08 module - check the value of these 2 x Bits and use the same setting on the new hex08 module. If you don't have this information, perhaps set both switches to zero (i.e. not ticked) - again I'm guessing?
Don
|
|
|
Post by ilbabis on Apr 25, 2021 18:56:32 GMT
Okay, so what I did was, I got the original string, before I touched anything (found it the module history) , pasted it, and I got the " No basic setting " error.
I then run a calibration and the fault was cleared. So, all and all I guess that was the solution for me.
Don, the 6 and 7 were already 0 , so that wasn't the case.
Thank you very much anyway !
|
|
|
Post by gokturks on Aug 26, 2023 4:38:13 GMT
Hi. I have same problem on my tiguan mk2 Flaps not work well . I tired combination ac+flaps swich button but not help. , do you fixed yours. If yes can you help me. Thanks
|
|