|
|
AFS
Apr 15, 2021 20:43:48 GMT
via mobile
Post by 1highgti on Apr 15, 2021 20:43:48 GMT
After lowering my gti and using obd11 too adjust the adaptive headlights I can’t get the error message too go away the car is a 2018 vw gti I’ve looked at everything and can’t seem too get the error off anyone run into this before?
|
|
|
|
Post by dv52 (Australia) on Apr 16, 2021 20:05:27 GMT
Assuming that your car has a hex55 module - try this (it's a 2-part procedure): Important: Make sure the car is fully settled on its suspension and that the vehicle is on level ground
Procedure 1
- Select hex 55 - Xenon Range module
- Select Basic Settings
- Select Basic headlamp setting and start the procedure
- This is where you would adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target - but in your case go to the next step
- Wait a period of time (suggest 10 seconds)- then stop the procedure
Procedure 2 (still in Basic Settings)
- Select Acknowledge basic setting and start the procedure
- The reference settings from Procedure 1 above should now be "recorded" in the module
- Wait a period of time (suggest 3 seconds)- then stop the procedure
- Back-out of the module, clear any error codes and exit OBD11 software (don't forget to disconnect the OBD11 dongle)
Don |
|
