Post by racingjustin51 on Jan 20, 2017 5:23:03 GMT
Thank you in advance for any help related to this. I installed the 1K0 051 437 Volk L bluetooth kit in my 09 CC today. The radio I have is the RCD-510(chinese market) . Install went fine however when I get to coding I entered the values below. However I cannot figure out how/where to "Reset the telephone to "coded"
this is the instructions
1.5 Coding the hands free phone kit
− Connect a vehicle diagnosis, measurement and information
system to the vehicle.
− Select the operating mode "Vehicle Self-Diagnosis" at the
vehicle diagnostics, measurement and information system.
− Select the following menu points one after another:
◆ 19 Databus diagnostic interface
◆ 007 Coding (Service $1A)
◆ 77 Telephone
− Reset the telephone to "coded".
− The follow the guide and enter the relevant vehicle data.
− Code the telephone controller as follows:
byte devices without stereo
devices with stereo
phone input 1)
phone input 2)
0 $40 $41
1 $21 $21
2 $20 $20
Can anyone provided any input or ideas?
Thank you!!!
this is the instructions
1.5 Coding the hands free phone kit
− Connect a vehicle diagnosis, measurement and information
system to the vehicle.
− Select the operating mode "Vehicle Self-Diagnosis" at the
vehicle diagnostics, measurement and information system.
− Select the following menu points one after another:
◆ 19 Databus diagnostic interface
◆ 007 Coding (Service $1A)
◆ 77 Telephone
− Reset the telephone to "coded".
− The follow the guide and enter the relevant vehicle data.
− Code the telephone controller as follows:
byte devices without stereo
devices with stereo
phone input 1)
phone input 2)
0 $40 $41
1 $21 $21
2 $20 $20
Can anyone provided any input or ideas?
Thank you!!!