Post by mickstan on Mar 14, 2021 20:53:34 GMT
2013 VW TDI Sportwagen 137,000 miles, Android, original OBD11 device, PRO.
LIVE DATA selected, Engine.
"Last Regeneration" seems to be stuck at 155 miles and 3.6 something gallons ago.
"Requested Regenerations" always shows 3, it never changes.
"DPF Soot Load" seems stuck at 138ml Ash and 9.90 Soot Load
The car is NOT deleted and is 100% factory original, I am the original owner.
No CEL.
I know for a fact the car goes into regen mode. I use Torque to monitor EGT and CAT1 temps while driving. Yesterday the temp shot up to 1482 degrees for almost 15 miles on the interstate. I drove the car 70 miles, but the "Last Regen" showed it happened 155 miles ago, the same as it always does.
I've had the device for over a year, but these values never change.
Is the adaptation messed up? Do I need to go into long coding to access the correct values somewhere? Can I reset or clear the reported values back to zero?
LIVE DATA selected, Engine.
"Last Regeneration" seems to be stuck at 155 miles and 3.6 something gallons ago.
"Requested Regenerations" always shows 3, it never changes.
"DPF Soot Load" seems stuck at 138ml Ash and 9.90 Soot Load
The car is NOT deleted and is 100% factory original, I am the original owner.
No CEL.
I know for a fact the car goes into regen mode. I use Torque to monitor EGT and CAT1 temps while driving. Yesterday the temp shot up to 1482 degrees for almost 15 miles on the interstate. I drove the car 70 miles, but the "Last Regen" showed it happened 155 miles ago, the same as it always does.
I've had the device for over a year, but these values never change.
Is the adaptation messed up? Do I need to go into long coding to access the correct values somewhere? Can I reset or clear the reported values back to zero?