|
|
Post by sparky on Jan 14, 2017 18:55:16 GMT
Anyone know how to set the Tach and Speedo sweep at start-up on the MK5 R32? I know this can be done using the VAGCOM software and cable, but having a hard time figuring it out using this ODBEleven app.
|
|
|
|
Post by Matthew on Jan 18, 2017 19:52:21 GMT
You can't do this for the MK5 cluster. You can only do it with the MK6 and newer.
You would have to swap the newer MK6 cluster in your MK5 R32 to make it work. But in doing so, you would have to switch off the immobilizer or swap out the ECU and key barrel (from the same MK6 or newer car to make it work).
Note: to get your engine to run, you have to swap all three components (cluster, ECU and Key barrel with controller).
If you swap the cluster only, your car will start and run of 1 second, then shut off (you would then have to restart the engine again for it to shut off a second later).
I have VAGCOM, and it isn't possible for the MK5 (cluster too old).
|
|
|
|
Post by sparky on Jan 31, 2017 20:27:50 GMT
Thanks for the info..I'm finding that there is very little the ODBEleven will do for MK5 R32's other than read error codes and live data. Is that kind of a know issue?
|
|
|
|
Post by Matthew on Jan 31, 2017 22:10:46 GMT
Lets try something new. Do an export or your current configuration or post your HISTORY from the OBDeleven app here. I'll use VCDS to see what options are available for your R32 using an official copy of VCDS and show you the OBDeleven equivalent.
|
|
|
|
Post by black gti on Sept 12, 2018 21:09:16 GMT
Great!
I'm interested in that as well!
|
|
