|
|
Post by hiro.s on Mar 3, 2021 6:24:27 GMT
I did the following coding in an attempt to disable the start / stop.
19-Gateway => Start / Stop Start limited voltage => 7.6V => 12.1
However, the initial value was 9V. I rewrote it to 12V. However, the Start Stop operation did not stop. Does anyone know the cause?
|
|
|
|
Post by dv52 (Australia) on Mar 3, 2021 20:19:42 GMT
hiro.s: on later model mk7.5s, VW reinforced the way SS is integrated into the CAN network - bottom line is that the tradition "voltage method" tweak no longer works. If your car doesn't have touch-type SS disable switch, you will need to install a physical auto-disabling switch Don
|
|
|
|
Post by rainerl on Mar 10, 2022 15:00:25 GMT
It does work on my 7.5.
However. Sometimes the motor turns off when i shift lever to park or neutral. Then i manually press the stop start button just to make sure it does not do it again. Rarher deceives the purpose. Trying a 12.5 voltage entry. See what happens
|
|
ilzul
New Member
Posts: 20 
|
Post by ilzul on Mar 17, 2022 17:11:36 GMT
Check if you have access to "em start stop requirement ambient temperature".
On the maximum value set to 50.0 instead of -50.0 .
|
|
yenerunsall
New Member
https://www.gizliozellikacma.com
Posts: 5
|
Post by yenerunsall on Apr 5, 2022 21:53:05 GMT
This can be canceled with a different device. The device is a well-known device, but I think it is forbidden to write its name here.
|
|
