erv
New Member
Posts: 1
|
Post by erv on Jan 19, 2021 8:01:50 GMT
Hello, i tried to retrofit rearview camera to my 8/2016 model 2017 AUDI A4 B9, but when trying to access rear view camera module i get message “Control unit not responding. Check ignition and try again”
I added this module and it is marked as 6C in black circle.
I would like to know 1. What is causing this problem? 2. Can I make this black circle red/green so it would allow me to enter into it or this cannot be changed since I added this module.
Thank you for your help.
|
|
arnau
New Member
Posts: 15
|
Post by arnau on Jan 22, 2021 15:56:45 GMT
I understand, that the can connection to the gateway module under the rear seat is not ok, check this. Another reason would be there's no power to the camera, so you should check the 12V connection on the boot fusebox
|
|
|
Post by jmh1664 on Feb 4, 2021 9:35:31 GMT
I had this. Disconnect the battery for a few minutes. Mine was fine after that.
|
|
pt16a4
Junior Member
Posts: 83
|
Post by pt16a4 on Jan 2, 2022 23:16:27 GMT
I am in the same situation as Erv - everything looks to be correctly connected, but 6C remains unresponsive (black circle). Has anyone tried/had luck with the suggested solution of disconnecting the battery, then reconnecting?
|
|
|
Post by manias on Mar 2, 2022 21:57:03 GMT
Same problem ... did any found any solution???
|
|