|
Post by steve78 on Jan 1, 2021 20:47:57 GMT
Hi there, I used obdeleven about 5 months ago to calibrate my suspension with no problems, I've gone to do it again today, gone to calibrate my suspension on a 08 Q7 using obdeleven, enter the values, press 1 in channel 5, it accepts it but then says "marginal conditions not been met" and doesn't alter the height of the suspension. I think my front left was 242 Front right was 245 Left rear was 255 Right rear was 265 So not hugely out Any ideas please? Many thanks Steve
|
|
|
Post by dadofsweden on Jan 14, 2021 11:38:21 GMT
Im following this thread,,,,
|
|
fatos
New Member
Posts: 2
|
Post by fatos on Feb 8, 2021 23:21:15 GMT
here are the procedures u have to do. hope it helps.
|
|