|
|
Post by mnbvcxz6 on Dec 4, 2020 18:45:10 GMT
Hi All,
I'm looking at purchasing a rearview camera for my 2016 seat Leon from carsystems.eu.
Would anyone have the coding instructions for it? Or have experience doing it?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 5, 2020 13:33:17 GMT
These are the instructions that i have
Connect the signal cables to the Quadlock (Blue Connector) Where PIN 6 is positive and PIN 12 is the video ground. 1 - Module 5F 2 - Coding (Byte mode) 3 - Byte 19 - (Activate Bit 4) It can also be done in text mode in Byte 19 Rear View Low by setting it on. |
|
peteb
New Member
Posts: 12
|
Post by peteb on Dec 26, 2020 12:55:53 GMT
Can anyone tell me where the quad lock connector is in the car? And how to gain access to it?
|
|
peteb
New Member
Posts: 12
|
Post by peteb on Dec 26, 2020 13:28:11 GMT
Where is the best place to gain access to the can bus for the orange and brown cables do you know?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 26, 2020 13:40:00 GMT
|
|
peteb
New Member
Posts: 12
|
Post by peteb on Dec 31, 2020 18:08:51 GMT
Hi there,
I've connected the camera and made the coding changes as your above message but camera just shows up as a black screen.
Fault on 5f module is rear camera no signal
I connected the can bus to the green connector (directly to the left of blue connector) pin 6 and 12 which I'm thinking is incorrect?
Any ideas?
Thanks for your help so far
|
|
peteb
New Member
Posts: 12
|
Post by peteb on Dec 31, 2020 18:38:57 GMT
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 1, 2021 21:40:06 GMT
Sorry I have not got round to fitting my one yet.
Two things I am aware off firstly do you have the correct type of camera I think its NTFS format needed, should be in the details above.
Secondly have you connected the camera to a good power supply (eg one that is provided when ignition on.
|
|
