Touareg CR Coding and Adaptations

My first project of "Lane Assist Activation", like a charm without error.
Please do a backup before.
Procedure copied from an Audi A8 forum

1)
Long coding
Control unit: A5 Front Sensors Driver Assistance System
Values:
ALDW_lane_assist:
Old value: not_installed
New value: installed

2)
Adaptation
Control unit: 5F Information Control Unit
Name: Car_Function_List_BAP_Gen2
Values:
LDW_HCA_0x19:
Old value: Not activated
New value: activated
LDW_HCA_0x19_msg_bus:
Old value: Flexray Databus
New value: keep Flexray Databus

3)
Adaptation
Control unit: 5F Information Control Unit
Name: Car_Function_Adaptations_Gen2
Values:
menu_display_Lane_Departure_Warning_over_threshold _high:
Old value: Not activated
New value: activated
menu_display_Lane_Departure_Warning:
Old value: Not activated
New value: activated

4)
Long coding
Control unit: 44 Steering Assistance
Values:
Heading Control Assistant:
Old value: not active
New value: active

5)
Long coding
Control unit: 09 Central Electrics
Values:
heading_control_config:
Old value: no_heading_control
New value: heading_control

6)
Long coding
Control unit: 17 Dash Board
Values:
Lane assistant:
Old value: No
New value: Yes
Byte 4 – bit 6 : Check

7)
NOTE: By default, ALA will kick in "late". If you want it to kick in early to keep you in the lane, then:

Adaptation
Control Unit: A5 Front Sensors Driver Assistance System
Name: Active_lane_departure_warning_point_of_intervention
Old value: Selection_over_menu_default_late
New: Selection_over_menu_default_early
8)
Module 82/Head Up Display
Long Coding
Lane Assistant - change to 'available'

Final notes: ALA only kicks in above a certain speed. You will then see white lines on the bottom right of your VC if the above steps work. Once you get above a certain speed and the camera detects the lines on the road, the respective side will turn green. If you cross over, it'll nudge you back into your lane and if you force it to swerve past, it'll turn red and your steering wheel will vibrate. There's a way to increase the vibration strength too,
To change steering wheel vibration strength go to the A5 module, under adaptations find the one called "lane_Departure_warning_steering_wheel_vibration_strength" and change accordingly. Default/old value is medium.

This Code is working well for my Touareg 3. I also have coding for telephone number show at heads up display. The coding is very easy.

1. go to modual 82
2. coding
3.long coding helper
4.choose 2
5. choose bit4 to click
6. exit long coding helper
7.the new coding for my car is AA40D0
8. do it
9. Coding have been accepted
10. restart the car, and testing now the incoming telephone number should be activated at heads up display.

Even if I don't have Acc, after the lane assist I activate the ea-emergency assist at A5 unit Long coding. It's working as a charm. Only turn signals not flashing when braking. I try different options at 46 unit (emergency braking..) but not working.
It's enough for me !

They are already. They are just not slow like a toyota.

can the frequency be adjusted that dynamic effect to be more visible?
thx!

I don't know if this has already been commented on here.

I would like to coding "Automatic air recirculation mode of the Climatronic and Air Care - Climatronic with allergen filter" to always ON. Is this possible.



thank you in advance

Сделал air постоянно.