Post by rickny on Oct 25, 2020 14:50:09 GMT
Using the next gen with pro on my account and 1.36 of the iOS app on my 2018 Audi S4. I had replaced the MMI controller in the center console, which triggered a B201A00 Checking Software Management fault. Followed the instructions for clearing that by using an XOR calculator to get the updated value to enter in 5F-Adaptations, Confirmation of installation change.
When I perform that operation and slide the bar in the iOS app to do it, it gets stuck on the process of sending it and never returns with a successful confirmation. It never shows the operation in my History - but — it did allow the fault to clear and not return. Is this a bug or is it because when that adaptation is used, it does not actually change the original value? I also have an Android device to check if the same behavior occurs there.
Thanks
Rick
When I perform that operation and slide the bar in the iOS app to do it, it gets stuck on the process of sending it and never returns with a successful confirmation. It never shows the operation in my History - but — it did allow the fault to clear and not return. Is this a bug or is it because when that adaptation is used, it does not actually change the original value? I also have an Android device to check if the same behavior occurs there.
Thanks
Rick
