|
|
Post by gtiguy on Nov 22, 2016 3:19:02 GMT
I am having issues with lowering the volume of the soundaktor. I go into its module, adaptations, set value to 0, press green check....but then nothing. It doesn't say "adaptation accepted" nor does it change the volume. I noticed there aren't any numbers or line items showing the name or current setting when you open up the adaptation page. Another thing I noticed is it doesn't show up in my history so I'm pretty sure it's not working.
Anyone have any ideas?
Car:
MY16
Autobahn PP / LP / DCC
|
|
|
|
Post by dv52 (Australia) on Nov 22, 2016 6:44:45 GMT
gtiguy:hmm.......... difficult to respond because it's a very simple tweak (doesn't need a security code). Is the color of the circle surrounding the "A9" green on the control module list? If it is, it means that the module has been correctly assigned to the (CAN) Gateway module. If it's surrounded by a black circle, there are problems with the gateway list!
Don
|
|
|
|
Post by gtiguy on Nov 22, 2016 18:19:59 GMT
Here is a video I took of exactly what's going on. The A9 actuator channel is green and should be communicating. Another thing I noticed is the "central electronics" channel is red but I think everyone's is red.
Any help would be greatly appreciated.
|
|
|
|
Post by dv52 (Australia) on Nov 22, 2016 21:51:22 GMT
Here is a video I took of exactly what's going on. The A9 actuator channel is green and should be communicating. Another thing I noticed is the "central electronics" channel is red but I think everyone's is red. Any help would be greatly appreciated. gtiguy: ok, the difference between your video and the video below is that you don't appear to have the green tick in a circle (bottom RHS)- which activates the changed entry for the adaptation channel. Not sure why this is missing on your device (unless it's below the screen in your video). Have you done a scan of the car to assertain if all the modules are communicating correctly? If so, send yourself an email of the scan results and post a copy of the report here for us to look-at Don PS: the presence of the red dot surrounding the hex address number for a control module (like central electrics) indicates that there are error messages (DTCs) in the module. Performing a scan of the car will uidentifdy the nature of these DTCs |
|
|
|
Post by gtiguy on Nov 23, 2016 17:21:20 GMT
Hi Don, I finally figured out what I was doing wrong. I wasnt clicking on the "volume of structure borne actuator" before entering the value. So the actual adaptation wasnt ever showing up because I wasnt selecting it  Im a complete idiot sometimes haha. Thanks for your help Don |
|
