|
Post by muppymk7 on Jul 7, 2020 13:59:05 GMT
Hi I just recently installed a headunit in my mk7 2014 gti My reverse camera doesn’t work. I have to code it but I don’t no where to start can anyone help me here Thank you
|
|
|
Post by dv52 (Australia) on Jul 7, 2020 20:35:36 GMT
Hi I just recently installed a headunit in my mk7 2014 gti My reverse camera doesn’t work. I have to code it but I don’t no where to start can anyone help me here Thank you ^ ^^^^ muppy: hi I assume that you have the standard Low-line camera. if so, the software switch to tell the Information control unit 1 module @ address hex5F to start operating the RVC is in Byte 19, Bit 4. So - it's done like this:
- Connect to the OBD11 dongle and go to the screen that shows the control modules listed on the left-side
- Scroll down the list of control modules until you see Information control unit 1 (it has 5F in a circle) - select this module
- on the left side, select Long coding
- using the side arrows - navigate to Byte 19
- Place a tick in Bit 4
- Press the green tick in the center circle to save the change
Don
|
|